Here are all the actual test exam dumps for IT exams. Most people prepare for the actual exams with our test dumps to pass their exams. So it's critical to choose and actual test pdf to succeed.

Exam 4A0-220 Topic 1 Question 28 Discussion

Actual exam question for Nokia's 4A0-220 exam
Question #: 28
Topic #: 1
What does Test Mode do in an SNC?

Suggested Answer: B Vote an answer

Explanation
Test Mode is a feature of the Link Management Protocol (LMP) that allows testing the connectivity and functionality of a link or a TE-link. Test Mode can be initiated by either end of a link or a TE-link by sending a Test Message with a Test ID and a Test Pattern. The Test Message is sent over the control channel of the link or the TE-link and contains information such as the source and destination IP addresses, the link ID, and the test parameters. The receiving node then verifies the Test Message and sends back a TestStatusAck message with the same Test ID and Test Pattern. The TestStatusAck message indicates whether the test was successful or not, and if not, what was the reason for failure. Test Mode can be used to check if a link or a TE-link is operational, if it has any errors or faults, or if it supports certain features or capabilities. References : Nokia GMPLS-controlled Optical Networks Course | Nokia, RFC 4204 - Link Management Protocol (LMP)

by Faithe at Aug 26, 2025, 03:06 PM

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.