QUESTION NO: 1
Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over Fast Ethernet?
Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over Fast Ethernet?
Correct Answer: A
Vote an answer
QUESTION NO: 2
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?
Correct Answer: A
Vote an answer
QUESTION NO: 3
What one of the feature is associated with single-mode fiber-optic cable?
What one of the feature is associated with single-mode fiber-optic cable?
Correct Answer: A
Vote an answer
QUESTION NO: 4
Which command sends an echo request packet to the largest host and then waits for an echo response message?
Which command sends an echo request packet to the largest host and then waits for an echo response message?
Correct Answer: A
Vote an answer
QUESTION NO: 5
Refer to the exhibit.
Which type of cable us used on the ATM card?
Refer to the exhibit.
Which type of cable us used on the ATM card?
Correct Answer: C
Vote an answer
QUESTION NO: 6
Which three pieces of information about a device can be seen from the show version command? (Choose three)
Which three pieces of information about a device can be seen from the show version command? (Choose three)
Correct Answer: B,D,E
Vote an answer
QUESTION NO: 7
Which bits represent the boot field in the configuration register value?
Which bits represent the boot field in the configuration register value?
Correct Answer: C
Vote an answer
QUESTION NO: 8
Which port displays the bootup process on a Cisco device?
Which port displays the bootup process on a Cisco device?
Correct Answer: B
Vote an answer
QUESTION NO: 9
From a Windows command prompt, which command displays the local IP address of a computer?
From a Windows command prompt, which command displays the local IP address of a computer?
Correct Answer: D
Vote an answer
QUESTION NO: 10
Refer to the exhibit.
Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)
Refer to the exhibit.
Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)
Correct Answer: B,E
Vote an answer