Cisco Certified Network Associate(CCNA) - 640-802 Free Exam Questions

A. B514:82C3::0029:EC7A:EC72

B. B514:82C3::0029:EC7A:0:EC72

C. B514:82C3:0029:EC7A:EC72

D. B514:82C3:0029::EC7A:0000:EC72

A. Bridges are faster than switches because they have fewer ports.

B. Bridges and switches learn MAC addresses by examining the source MAC address of each frame received.

C. Bridges and switches increase the size of a collision domain.

D. A switch is a multiport bridge.

E. A bridge will forward a broadcast but a switch will not.

A. ip route 0.0.0.0 0.0.0.0 209.165.200.226

B. ip route 209.165.200.0 255.255.255.0 192.168.1.250

C. ip route 0.0.0.0 0.0.0.0 s0/0/0

D. ip route 192.168.1.0 255.255.255.0 209.165.100.250

A. SwitchB(config)# ip default-network 192.168.8, 254 SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown

B. SwitchB(config-if)# interface FastEthernet 0/1 SwitchB(config-if )# ip default-gateway 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown

C. SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if )# ip default-gateway 192.168.8.254 255.255.255.0 SwitchB(config-if)# no shutdown

D. SwitchB(config)# ip default-gateway 192.168.8.254 SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown

E. SwitchB(config)# ip router 192.168.8.254 255.255.255.0 SwitchB(config-if)# interface FastEthernet 0/1 SwitchB(config-if )# ip default-gateway 192.168.8.254 255.255.255.0 SwitchB(config-if)# no shutdown

A. physical

B. transport

C. network

D. session

E. presentation

A. to decrease latency by increasing bandwidth

B. to confine network instability to single areas of the network

C. to speed up convergence

D. to reduce the complexity of router configuration

E. to lower costs by replacing routers with distribution layer switches

F. to reduce routing overhead

A. VTP pruning is used to increase available bandwidth in trunk links.

B. To configure a switch to be part of two VTP domains, each domain must have its own Password.

C. Each broadcast domain on a switch can have its own Unique VTP Domain.

D. When properly configured, VTP minimizes VLAN misconfigurations and configuration inconsistencies.

E. When properly configured, VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.

F. VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.

G. Client, server, and transparent are valid VTP modes.

A. copy TFTP: running-config

B. copy startup-config: TFTP:

C. copy TFTP: startup-config

D. copy running-config: TFTP:

A. Interface S0/0 on RouterA is configured with an incorrect subnet mask.

B. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

C. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.

D. The cable that is connected to S0/0 on RouterA is faulty.

E. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.

F. Interface S0/0 on RouterB is administratively down.

A. 0

B. 1

C. 3

D. 2

E. 4

A. All ports will be in a state of discarding, learning, or forwarding.

B. This switch must be the root bridge for all VLANs on this switch.

C. All interfaces that are shown are on shared media.

D. Thirty VLANs have been configured on this switch.

E. All designated ports are in a forwarding state.

F. The bridge priority is lower than the default value for spanning tree.