Cisco Implementing Cisco IP Switched Networks - 642-813 Free Exam Questions

A. VLANs should be localized to a single switch unless voice VLANs are being utilized.

B. Routing may be performed at all layers but is most commonly done at the core and distribution layers.

C. Routing should occur at the access layer if voice VLANs are utilized. Otherwise, routing should occur at the distribution layer.

D. VLANs should be local to a switch.

E. Routing should not be performed between VLANs located on separate switches.

A. The two ends of the trunk allow different VLANs on the trunk.

B. The two ends of the trunk have different native VLAN configurations.

C. The two ends of the trunk have different EtherChannel configurations.

D. The two ends of the trunk have different duplex settings.

A. A heavy traffic load could cause BPDU transmissions to be blocked and leave a switching loop.

B. One or both of the two switch ports attached to the hub goes into the err-disabled state when a BPDU is received.

C. The switch port attached to LinkB does not transition to up.

D. The switch port attached to LinkA immediately transitions to the blocking state.

E. Both switch ports attached to the hub transitions to the blocking state.

A. IEEE 802.1w and IEEE 802.1s are compatible. IEEE 802.1d is incompatible. Switches S1 and S3 can pass traffic between themselves. Neither can pass traffic to switch S2.

B. IEEE 802.1d, IEEE 802.1w, and IEEE 802.1s are incompatible. All three switches must use the same standard or no traffic can pass between any of the switches.

C. Switches S1, S2, and S3 can pass traffic between themselves.

D. Switches S1, S2, and S3 can pass traffic between themselves. However, if the topology is changed, switch S2 does not receive notification of the change.

A. 30 seconds

B. None of the other alternatives apply

C. 10 seconds

D. 5 seconds

E. 1 minute

F. 5 minutes

A. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain A)

B. dynamic auto (VTP domain A) to nonegotiate (VTP domain A)

C. nonegotiate (VTP domain A) to nonegotiate (VTP domain B)

D. dynamic auto (VTP domain A) to dynamic auto (VTP domain B)

E. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain B)

F. dynamic auto (VTP domain A) to dynamic auto (VTP domain A)

A. MST00

B. MST01

C. None

D. The last MST instance configured

A. Switch(config-if)#spanning-tree bpduguard

B. Switch(config)#udld aggressive

C. Switch(config)#spanning-tree loopguard default

D. Switch(config-if)#spanning-tree bdpufilter

A. DTP

B. 802.1Q

C. ISL

D. VTP

A. When the number of secure IP addresses reaches 10, the interface will immediately shut down.

B. Interface FastEthernet 0/1 was configured with the switchport port-security protect command.

C. When the number of secure MAC addresses reaches 10, packets from unknown MAC addresses will be dropped.

D. Interface FastEthernet 0/1 was configured with the switchport port-security aging command.

E. Interface FastEthernet 0/1 was configured with the switchport port-security violation restrict command.

A. HSRP

B. GLBP

C. SLB

D. VRRP

E. RPR

F. RPR+

A. SVI VLAN 30 connects directly to the 10.1.30.0/24 network due to a valid glean adjacency.

B. The IP Cisco Express Forwarding configuration is capable of supporting IPv6.

C. VLAN 30 is not operational because no packet or byte counts are indicated.

D. Cisco Express Forwarding load balancing has been disabled.