Referring to the screen captures provided for this question,

what can you conclude about the two clients from the Packet Rate Distribution screens?
Which set of configuration commands are needed to make VLAN 10 the management VLAN?
What new firewall action was added specifically for use with Aruba's Content Security Service?
VisualRF supports import of floor plans from:
Which statement is true about the Content Security License?
Where are Aruba Vendor Specific Attributes (VSA) programmed?
Referring to the above screen capture, if an administrator desires to change a specific AP into an AM without assigning the AP to a new group, which menus could be used?

Which command, when executed on a master controller, will show the APs connected to an lms?
What APs can be configured as a Certificate based RAP?
A customer has configured a 3000 controller with the following commands:
Vlan 55
Vlan 56
Vlan 57
Interface gigabitethernet 1/0 switchport mode trunk
switchport trunk native vlan 55
switchport trunk allowed vlan 55-57
Which of the following sentences best describes this port?
In a master-local controller scenario, where is the mobility domain defined?
When creating a firewall policy, which of the following parameters are required? (Choose all the correct answers.)
An Aruba controller is configured with the correct IP address and gateway information and is connected to the corporate LAN via a core layer 2 switch. An access point is provisioned with AP name and group and connected to a different switch on the corporate LAN that has IP connectivity to the core layer 2 switch. The AP powers on and connects to the LAN, but the wireless radios do not power on.
Which could cause this condition? (Choose all of the correct answers.)
Screenshots of the Captive Portal authentication profile and server group of a guest network are displayed above.

How was the user authenticated?