QUESTION NO: 1
In OSPF, when you configure an Extreme switch with router priority of 0, what happens?
In OSPF, when you configure an Extreme switch with router priority of 0, what happens?
Correct Answer: C
Vote an answer
QUESTION NO: 2
By default OSPF hello packets are sent out every
By default OSPF hello packets are sent out every
Correct Answer: B
Vote an answer
QUESTION NO: 3
The pre-empt option in VRRP is enabled by default on Extreme Networks switches. Pre-empt ensures that
The pre-empt option in VRRP is enabled by default on Extreme Networks switches. Pre-empt ensures that
Correct Answer: D
Vote an answer
QUESTION NO: 4
Is it possible on a single switch, to put different physical ports, belonging to the same VLAN, into different STPD's?
Is it possible on a single switch, to put different physical ports, belonging to the same VLAN, into different STPD's?
Correct Answer: C
Vote an answer
QUESTION NO: 5
Dealing with an Access Control List on Extreme switches it's required to include a precedence number when configuring the default rule.
Dealing with an Access Control List on Extreme switches it's required to include a precedence number when configuring the default rule.
Correct Answer: B
Vote an answer
QUESTION NO: 6
Which CLI command configures DVMRP on all IP multicast interfaces.
Which CLI command configures DVMRP on all IP multicast interfaces.
Correct Answer: C
Vote an answer
QUESTION NO: 7
Which of the following IP destination addresses can be used for multicast streams?
Which of the following IP destination addresses can be used for multicast streams?
Correct Answer: C
Vote an answer
QUESTION NO: 8
in IS-IS level 1/2 routers act as border routers to their respective areas, providing connectivity to other areas.
in IS-IS level 1/2 routers act as border routers to their respective areas, providing connectivity to other areas.
Correct Answer: A
Vote an answer
QUESTION NO: 9
On an Extreme Networks switch, how many bits comprise an OSPF area ID?
On an Extreme Networks switch, how many bits comprise an OSPF area ID?
Correct Answer: C
Vote an answer
QUESTION NO: 10
The OSPF LSA Link State type that all OSPF routers generate is the LSA LS type 1 Router LS
The OSPF LSA Link State type that all OSPF routers generate is the LSA LS type 1 Router LS
Correct Answer: B
Vote an answer
QUESTION NO: 11
An Ethernet multicast MAC address always starts with 01005E.
An Ethernet multicast MAC address always starts with 01005E.
Correct Answer: A
Vote an answer
QUESTION NO: 12
Although you can specify sequence numbers for different ACL entries, the Summit 1i switch checks incoming traffic on a match with the ACL entries in the order of their time in configuration
Although you can specify sequence numbers for different ACL entries, the Summit 1i switch checks incoming traffic on a match with the ACL entries in the order of their time in configuration
Correct Answer: B
Vote an answer
QUESTION NO: 13
When configuring a Summit 5i for OSPF routing, it is recommended to manually configure the OSPF router-id rather than setting the router-id set to automatic.
When configuring a Summit 5i for OSPF routing, it is recommended to manually configure the OSPF router-id rather than setting the router-id set to automatic.
Correct Answer: A
Vote an answer
QUESTION NO: 14
In PIM sparse mode the Bootstrap Router election is based on the highest IP address.
In PIM sparse mode the Bootstrap Router election is based on the highest IP address.
Correct Answer: A
Vote an answer