F5 BIG-IP Administration Install, Initial Configuration, and Upgrade - F5CAB1 Free Exam Questions

A. By checking the Dashboard output in the Statistics tab in the GUI.

B. By running tmsh show /sys provision and reviewing the specific module in the output.

C. By running tmsh show /sys cpu and reviewing the specific module provisioned output.

D. By running the top command and reviewing the output for the provisioned module.

E. By going to System ?Resource Provisioning and hovering over the CPU section colors.

A. The system verifies the internal checksum

B. The system copies the image to /var/local/images/

C. The system performs a reboot into a new partition

A. A virtual IP used for SSL offloading

B. An IP address used only for the internal network

C. An IP address used for routing purposes only

D. An IP address used for management and traffic handling

A. Same IP address on both devices

B. Different software versions on each device

C. Configuration of load balancing on both devices

D. Same hardware model and version of software

A. iRule

B. SSL Profile

C. Pool

D. Route

A. Assign an administrative password

B. Install a software license

C. Set up SSL certificates

D. Set up self-IPs

A. Reset the Device Trust, apply the update to each node separately, reboot both nodes, then re- establish the Device Trust.

B. Update the standby node first and reboot it to the newly updated boot location, failover to the newly updated node and verify functionality. Repeat the upgrade procedures on the next node, which is now in standby mode.

C. Update the active node first, reboot to the newly updated boot location and verify functionality, then push the update from the active to the standby node and reboot the standby node.

D. Update both nodes in the HA pair, then reboot both nodes simultaneously to ensure they run the same software version.

A. show /sys management-ip

B. list /sys management-ip

C. run /util bash ifconfig mgmt