Fortinet FCSS - Network Security 7.6 Support Engineer - FCSS_NST_SE-7.6 Free Exam Questions

A. A firewall policy that allows all ICMP traffic from port3 to port1.

B. Enable asymmetric routing under config system settings.

C. Modify the default gateway on the laptop from 10.1.0.2 to 10.2.0.2.

D. Change the configuration from strict RPF check mode to feasible RPF check mode.

A. The session continues to permit traffic on the new primary device after failover. without requiring the client to restart the session with the server.

B. The session state is preserved but the kernel will re-evaluate the session because the routing information will be flushed

C. The session will be removed from the session table of the secondary device because the TCP session is not yet fully established.

D. The session is synchronized with the secondary device, however, because application control is applied.
the session is marked dirty and has to be reevaluated after failover.

A. An inbound route-map on local router is blocking the prefixes from neighbor 100.64.3.1.

B. The BGP session with peer 10.127.0.75 is up.

C. The router 100.64.3.1 needs to update the local AS number in its BGP configuration in order to bring up the 8GP session with the local router.

D. All of the neighbors displayed are part of a single BGP configuration on the local router with the neighbor-range set to a value of 4.

A. You can configure automation stitches to take parameters from previous actions as input for the next action if the automation stitches are set to execute actions in sequence.

B. You can configure automation stitches to modify packet headers and payloads if specific traffic triggers an anomaly IPS event.

C. You can configure automation stitches to insert a delay between actions if the automation stitches are set to execute actions in parallel.

D. You can configure automation stitches to run diagnostic commands and attach the results to an email message when CPU or memory usage exceeds specified thresholds.

A. The port1 default route has a lower distance than the default route using port2.

B. The port2 interface is disabled in the FortiGate configuration.

C. The port1 default route has a higher priority value than the default route using port2.

D. The port1 default route has a lower priority value than the default route using port2.

A. This session will be unaffected by routing changes. The routing changes will apply only to new sessions.

B. The session information will not change unless the current route has been removed from the routing table.

C. The session will be flagged as dirty but no route lookups will be performed.

D. The session information will not change even when the active route has been removed from the routing table.