QUESTION NO: 1
5G RAN 2.0 version gNodeB logical cells and sector devices use the command ANDD NRDUCELLTRP to complete the binding.
5G RAN 2.0 version gNodeB logical cells and sector devices use the command ANDD NRDUCELLTRP to complete the binding.
Correct Answer: A
Vote an answer
QUESTION NO: 2
In version 5G RAN 2.0, how many 100MHz NR cells does AAU5613 support?
In version 5G RAN 2.0, how many 100MHz NR cells does AAU5613 support?
Correct Answer: C
Vote an answer
QUESTION NO: 3
Execute "route add 10.10.10.0 mask 255.255.255.0 192.168.5.1 -p" in the cmd window of the test computer, which one describes the error below?
Execute "route add 10.10.10.0 mask 255.255.255.0 192.168.5.1 -p" in the cmd window of the test computer, which one describes the error below?
Correct Answer: B
Vote an answer
QUESTION NO: 4
What is the length of the TTI scheduled in the 5G NR?
What is the length of the TTI scheduled in the 5G NR?
Correct Answer: C
Vote an answer
QUESTION NO: 5
After the new NSA network is turned on, which of the following phenomena can be observed?
After the new NSA network is turned on, which of the following phenomena can be observed?
Correct Answer: A,C,D
Vote an answer
QUESTION NO: 6
CPRI fiber is recommended to use multimode fiber when the BBU and RRU are connected more than 150 meters.
CPRI fiber is recommended to use multimode fiber when the BBU and RRU are connected more than 150 meters.
Correct Answer: A
Vote an answer
QUESTION NO: 7
How many DEVIPs are supported for 5G RAN2.0 main control single-board Ethernet interface configuration?
How many DEVIPs are supported for 5G RAN2.0 main control single-board Ethernet interface configuration?
Correct Answer: C
Vote an answer
QUESTION NO: 8
Under normal circumstances, when the RSRP signal of the NR base station is lower than that, users start to buffer and freeze when watching 1080P video
Under normal circumstances, when the RSRP signal of the NR base station is lower than that, users start to buffer and freeze when watching 1080P video
Correct Answer: B
Vote an answer
QUESTION NO: 9
In the NSA network, if each gNodeB is assigned two logical IP addresses, it is recommended that S1-u use the same 1P address as which of the following?
In the NSA network, if each gNodeB is assigned two logical IP addresses, it is recommended that S1-u use the same 1P address as which of the following?
Correct Answer: B
Vote an answer
QUESTION NO: 10
Regarding NR physical layer processing, which of the following describes the error?
Regarding NR physical layer processing, which of the following describes the error?
Correct Answer: D
Vote an answer
QUESTION NO: 11
What configuration modules does gNodeB wireless data configuration include?
What configuration modules does gNodeB wireless data configuration include?
Correct Answer: A,C,D
Vote an answer
QUESTION NO: 12
In order to obtain a high upstream rate, the transmit power of the CPE needs to be set to the maximum power of the generator
In order to obtain a high upstream rate, the transmit power of the CPE needs to be set to the maximum power of the generator
Correct Answer: A
Vote an answer
QUESTION NO: 13
In which of the following states is the gNodeB maintenance mode referred to as an engineering state?
In which of the following states is the gNodeB maintenance mode referred to as an engineering state?
Correct Answer: B,C,D
Vote an answer
QUESTION NO: 14
If the main control board UMPT uses a 10Gbps optical module when the NR base station is turned on, the ETHPORT of GTRANSPARA must be configured to 10Gbps and cannot be configured to slow down.
If the main control board UMPT uses a 10Gbps optical module when the NR base station is turned on, the ETHPORT of GTRANSPARA must be configured to 10Gbps and cannot be configured to slow down.
Correct Answer: B
Vote an answer
QUESTION NO: 15
The ratio of upstream and downstream subframes in 5G RAN2.0 gNodeB cells supports SA5.
The ratio of upstream and downstream subframes in 5G RAN2.0 gNodeB cells supports SA5.
Correct Answer: A
Vote an answer