A network administrator needs to configure VRRP on VLAN 2 on two AOS-Switches. Which two settings must match on both switches?
Refer to the exhibit.

An AOS-Switch has the ACL shown in the exhibit. A network administrator then enters these commands:
Switch(config)# mac-access-list standard myACL
Switch(config-std-macl)# deny 007d.45cc.0000 0000.0000.ffff
How does this ACL treat these frames:
1 = 007d.45cc.ffff 2 = 007d.45cc.0000
A network administrator needs to control traffic based on Ethertype and Class of Service. What should the administrator configure for this purpose?
An AOS-Switch is configured to use captive portal and RADIUS to integrate with an Aruba ClearPass solution. What should the administrator do to enable the switch to accept change of authorization (CoA) messages from ClearPass?
Refer to the exhibits
Exhibit 1

Exhibit 2

Both Switch-1 and Switch-2 have an OSPF inter-area route to 10.2.0.0/16 with metric 10 in their IP routing table. Switch-3 has the default setting for ECMP. Based on the exhibits, what should the Switch-3 routing table display if the network operates as normal?
Refer to the exhibit.
Exhibit 1

Exhibit 2

Traffic between the servers in Area 1 takes a less optimal path rather than the link associated with VLAN
1000, subnet 10.0.0.0/30. Based on the exhibits, why is this the case?
An AOS-Switch enforces 802.1X authentication to an Aruba ClearPass server. A user connects but cannot receive network access, even though the ClearPass administrator finds an Access-Accept for the user on this switch. The switch administrator suspects that there is an issue with the dynamic settings returned by ClearPass.
Where should the administrator look for information about these settings?
What is a reason to create a virtual link between two OSPF routers?
Which technologies can prevent split brain in a VSF fabric that includes Aruba 2930F switches?
A company deploys AOS-Switches at sites with inexperienced IT staff. The main office network administrators want to monitor thresholds to generate alerts on branch switches. What should be set up for this purpose?
What is the minimum requirement for a device to pass local MAC authentication (LMA) on an AOS-Switch?
Refer to the exhibit.

A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated link should forward the packet?
Network administrators need to configure a BGP neighbor on an AOS-Switch. What defines the neighbor as an iBGP neighbor?
Refer to the exhibit.

Network administrators want the network to use PIM-DM to route multicasts from Server 1 to receivers in VLAN 24.
Which protocols should the administrators enable on which VLANs on Switch-1?