CTS-I PDF Dumps 2025 Exam Questions with Practice Test
Dumps for Free CTS-I Practice Exam Questions
AVIXA CTS-I Exam Certification Details:
| Non-Member Exam Price | $575(USD) |
| Exam Code | CTS-I |
| Sample Questions | AVIXA CTS-I Sample Questions |
| Schedule Exam | Pearson VUE |
| MemberExam Price | $475(USD) |
NEW QUESTION # 229
The projector offset is:
- A. The orientation of the projector on the vertical axis.
- B. The position of the projector with respect to the seating area.
- C. The orientation of the projector on the horizontal axis.
- D. The position of the projector with respect to the exact center of the screen.
Answer: A
NEW QUESTION # 230
Which of the following are HDCP authentication steps?
Select all that apply.
Response:
- A. Key exchange
- B. Locality check
- C. Session exchange
- D. Audio and video sync check
Answer: A,B,C
NEW QUESTION # 231
A high pass filter is typically used during equalization for ___.
- A. Adding hum to the system.
- B. Removing rumble from an HVAC system.
- C. Eliminating potential hissing sounds in the system.
- D. Adding emphasis to the lower frequency range.
Answer: B
NEW QUESTION # 232
What will keep the tile from sagging after the loudspeaker is installed?
- A. Back box
- B. Tile Bridge
- C. Tile can
- D. Grille
Answer: B
NEW QUESTION # 233
The ISO numerical marking scheme on materials is used to:
- A. test the amount of impurities present in the material the hardware is made from
- B. calculate the weight of the material the hardware is made from
- C. calculate the length of the hardware
- D. indicate the strength of the material the hardware is made from
Answer: D
NEW QUESTION # 234
What command prompt would you use to discover the IP address of a device you are currently using?
Response:
- A. ipconfig
- B. arp
- C. ping
- D. loopback
Answer: A
NEW QUESTION # 235
Where should you assemble an AV rack?
- A. On the customer's jobsite
- B. At your company's shop
- C. At the manufacturer's factory
- D. On your company's truck
Answer: B
NEW QUESTION # 236
HDCP is capable of working over which of the following interfaces? (Choose all that apply.)
- A. DisplayPort
- B. HDMI
- C. HDBaseT
- D. MHL
Answer: A,B,C,D
NEW QUESTION # 237
What are best practices when evaluating facility conditions of a space that is ready for installation? (Select all that apply.)
- A. Make sure the site is clean and dust-free
- B. Note areas that may affect logistics
- C. Note if you will need an extension ladder
- D. Take pictures and document all existing conditions
Answer: A,B,C,D
NEW QUESTION # 238
For what reasons is it important to set system gain? (Choose all that apply.)
- A. To maximize clipping
- B. To minimize the gain structure
- C. To maximize S/N ratio
- D. To minimize distortion
Answer: C,D
NEW QUESTION # 239
Before audiovisual equipment can be brought to a site what MUST occur?
Response:
- A. General contractor must obtain a CO
- B. The rack must be wired
- C. All cable must be installed
- D. The site must be clean and dust free
Answer: D
NEW QUESTION # 240
What type of rack would you use for an AV event at a remote location?
Response:
- A. Stand-alone rack
- B. Portable shock-mount rack
- C. Gangable rack
- D. Portable with casters rack
Answer: B
NEW QUESTION # 241
If a digital signal is carried too far on a cable, the signal will become unreadable. This is called _____.
- A. The cliff effect
- B. The eye pattern effect
- C. The analog sunset
- D. The bit error rate
Answer: A
NEW QUESTION # 242
What type of termination technique is used for a BNC connector?
- A. Insulation displacement
- B. Stab and twist
- C. Crimp
- D. Solder
Answer: C
NEW QUESTION # 243
Which sequence of numbers depicts part of a logarithmic scale?
- A. 1, 13, 26, 49
- B. 1, 10, 100, 1000
- C. 1, 2, 3, 5, 8
- D. 1, 2, 3, 4
Answer: B
NEW QUESTION # 244
_____ draws all the odd lines of a video signal from top to bottom, then all the even lines in the same order.
- A. Interlaced scanning
- B. Progressive scanning
- C. The frame rate
- D. 1080p
Answer: A
NEW QUESTION # 245
In a dynamic microphone, there is a(n) _____ attached to a diaphragm and placed in a permanent magnetic field.
- A. condenser
- B. coil of wire
- C. ribbon
- D. electret
Answer: B
NEW QUESTION # 246
Why is proper weight distribution in a rack important?
- A. so the rack does not tip over
- B. so the AV technicians do not strain themselves installing gear
- C. so the left and right sides of the rack are an equal weight
- D. so the rack does not exceed 500 lbs. (227kg)
Answer: A
NEW QUESTION # 247
What does the first number in an aspect ratio represent?
Response:
- A. Height
- B. Length
- C. Width
- D. Depth
Answer: C
NEW QUESTION # 248
According to the ANSI/AVIXA V201.01:202X Image System Contrast Ratio (ISCR) standard, what is the minimum contrast ratio for basic decision-making tasks?
- A. 50:1
- B. 80:1
- C. 15:1
- D. 7:1
Answer: C
NEW QUESTION # 249
Estimating throw distance requires two values: ____ and ____.
- A. throw ratio; screen height
- B. projector cart; tape measure
- C. off-axis viewing location; throw ratio
- D. screen width; throw ratio
Answer: D
NEW QUESTION # 250
The impedance will _____ over the loudspeaker's entire frequency range.
- A. stabilize
- B. be exactly the same
- C. vary with strength
- D. not be the same
Answer: D
NEW QUESTION # 251
Individual pieces of rack mounted equipment are separated by signal type because:
- A. Audio equipment is heaviest and should be at the bottom of the rack.
- B. This helps protect the signals against induced noise.
- C. Logical groupings of equipment are easier for the user.
- D. Signals flow down, not up.
Answer: B
NEW QUESTION # 252
Which of the following are features of an audio signal generator?
Select all that apply.
Response:
- A. With a properly calibrated signal, can determine signal bit rate
- B. Can be helpful in measuring distortion
- C. Usually has both 1 kHz and 400 Hz signal outputs
- D. Generates sine wave and other signals used for setting system levels
Answer: B,C,D
NEW QUESTION # 253
What are key considerations when determining projector placement?
Select all that apply.
Response:
- A. Offset value
- B. Type of lens
- C. Throw distance
- D. Standard deviation
Answer: A,B,C
NEW QUESTION # 254
......
Check your preparation for AVIXA CTS-I On-Demand Exam: https://www.actual4test.com/CTS-I_examcollection.html
CTS-I Dumps PDF And Certification Training: https://drive.google.com/open?id=1oCPSoWN1TFdauVfnxsnHzVYVgqEN8vg9