Huawei H19-401_V1.0 Exam Prep Guide: Prep guide for the H19-401_V1.0 Exam
2026 New Preparation Guide of Huawei H19-401_V1.0 Exam
Huawei H19-401_V1.0 exam is an excellent opportunity for professionals to showcase their expertise in campus network planning and design. It provides a valuable certification that can help individuals advance their career and achieve their professional goals. Candidates who pass H19-401_V1.0 exam can be confident in their ability to design and implement secure and efficient networks that meet the needs of their customers.
Huawei H19-401_V1.0 exam is a comprehensive test that assesses the knowledge and skills of candidates in areas such as network architecture, network design, network security, and network troubleshooting. H19-401_V1.0 exam is designed to test the candidate's ability to design, implement, and maintain a campus network infrastructure that is secure, reliable, and scalable.
NEW QUESTION # 142
Which of the following key designs does OceanStor Dorado use to provide industry-leading performance? (Multiple Choice)
- A. Architecture for all-flash
- B. FlashLink intelligent disk control coordination algorithm
- C. End-to-end NVMe architecture
- D. Global shared distributed file system
Answer: A,B,C,D
NEW QUESTION # 143
It is recommended by WLAN network planning that the field strength coverage requirement in general areas is greater than -85dBm.
- A. True
- B. False
Answer: B
NEW QUESTION # 144
What does the reliability of NCE products include? (Multiple choice)
- A. VM level protection
- B. Service-level protection (active and backup protection, cluster protection, etc.)
- C. Remote disaster recovery
- D. Blade-level protection
Answer: B,C,D
NEW QUESTION # 145
What fault factors will trigger the active/standby switchover of USG12000? (Multiple choice)
- A. The physical status of the interface monitored by HRP is DOWN.
- B. The health check status monitored by HRP changes to DOWN;
- C. Insert the new interface board into the standby machine to complete the registration.
- D. Insert the new service board into the standby machine to complete the registration;
Answer: A,B,D
NEW QUESTION # 146
What is the correct description about the scenario channel configuration template of the configuration generation tool?
- A. Channel templates are only available to users of this channel and can be modified.
- B. Channel templates are available to all users
- C. Channel templates are available to all channel providers
- D. Channel templates are only available to users of this channel, but cannot be modified.
Answer: A
NEW QUESTION # 147
What attributes does the OceanStor Dorado NAS SMB file blocking feature support based on for file filtering?
- A. Creation time
- B. File size
- C. File type
- D. Access time
Answer: C
NEW QUESTION # 148
What is incorrect description about the features of campus business on-the-go cloud migration?
- A. Policy service, which provides policy configuration capabilities. It mainly configures security groups and access policies between security groups. It integrates AC3.0 and AC1.0 is optional.
- B. Policy enforcement points and authentication points can be deployed on different physical devices.
- C. IP-Group synchronization service, as the control plane of IP-Group, provides collection and distribution of correspondence between IP and security groups, and is integrated in AC3.0 and AC1.0
- D. Authentication & Portal service supports serving as an AAA server to provide authentication, authorization, and accounting capabilities. It is integrated in AC3.0 and is optional in AC1.0.
Accounting relies on a third party.
Answer: C
NEW QUESTION # 149
What are the advantages of POE switches compared to POE power injectors? (Multiple choice)
- A. PoE port can be managed remotely
- B. POE switches are low cost
- C. Can be managed centrally
- D. No additional power cord required
Answer: A,B,C,D
NEW QUESTION # 150
In the terminal plug-and-play scenario, when configuring authentication and authorization rules, the current commercial version can configure terminal authentication and authorization rules based on terminal type/operating system to achieve automatic access and differentiated authorization.
- A. True
- B. False
Answer: A
NEW QUESTION # 151
In the current single ACCAPWAP disconnected wireless service maintenance solution, PSK new user access can be supported.
- A. True
- B. False
Answer: A
NEW QUESTION # 152
The incorrect description of the deployment mode of iMaster NCE - Campus V300R022CO0 version is:
- A. LAN-WAN&POL integration scenario, the minimum cluster requires 3 physical servers; it has a distributed cluster deployment mode.
- B. LAN-WAN integration scenario, the minimum cluster requires 3 physical servers; it has a distributed 6- node/9-node/17-node deployment mode (nodes refer to the number of virtual machines)
- C. In the LAN management scenario, the minimum cluster requires 3 physical servers; it has a distributed 9-node/17-node deployment mode (nodes refer to the number of virtual machines).
- D. POL convergence scenario, the minimum cluster requires 3 physical servers; there is no distributed cluster yet.
Answer: A
NEW QUESTION # 153
Ethernet A-D Route (Type 1): distributes ES labels for horizontal splitting to prevent traffic from the same ES from looping back to the ES.
- A. True
- B. False
Answer: A
NEW QUESTION # 154 
Refer to the diagram above, which of the following statement about dynamic bandwidth mode is correct? (Multiple choice)
- A. As shown in Figure 3, when the path from RT1 to RT3 fails, because the main path has no way to go, the blue tunnel backup path is enabled. Since 50OM bandwidth has been occupied by purple, the remaining bandwidth of the 1G link is only 500M. The remaining bandwidth of the blue tunnel is only 500M. The colored tunnel can only use the remaining 50OM bandwidth. Insufficient bandwidth cannot be preempted from the low-priority purple tunnel where services have been deployed.
- B. As shown in Figure 2, creating a tunnel with priority 2 requires a bandwidth of 50OM. In dynamic bandwidth mode, when both the primary and secondary high-priority tunnels are up, the bandwidth of the secondary path can be shared by the low-priority tunnel. , so the tunnel with priority 2 is still considered to be able to use 1G on the link RT1-RT2-RT4-RT3, so the path calculation can be successful. As shown in Figure 2, purple is a tunnel with priority 2 and bandwidth 500M.
- C. If no SRv6 TE Policy is matched, select the SRv6 TE Policy with the default priority of this address family.
- D. As shown in Figure 1 above, the available bandwidth of TE tunnels for all links is 1G. Blue indicates priority 1 tunnels (the solid line is the primary and the dotted line is the backup), occupying 60OM bandwidth. The remaining available bandwidth of the link is 40OM
- E. The tunnel supports different priorities (0, 7), 0 indicates the highest priority, and 7 indicates the lowest priority. When a high-priority tunnel does not have a suitable path during path calculation, it can preempt a low-priority tunnel. That is, the bandwidth of the primary and secondary paths of high-priority tunnels is deducted, but the bandwidth of the secondary paths of high-priority tunnels can be shared by low-priority tunnels.
Answer: B,D,E
NEW QUESTION # 155
Regarding the multi-Hub scenario, which of the following descriptions is incorrect?
- A. Support multi-active Hub scenarios based on Spoke sites
- B. Support multi-hub scenarios based on business network segments
- C. A VPN can select two Hubs from multiple Hubs as branch interworking Hubs
- D. Branch interworking hubs in VPN can work in active-active mode
Answer: D
NEW QUESTION # 156
Which of the following filters is recommended to be used as a global configuration?
- A. Protection object filter
- B. Software filters
- C. Universal filter
- D. Hardware filter
Answer: D
NEW QUESTION # 157
In order to ensure the consistency of the active and standby configuration sequence of the firewall dual-machine hot standby deployment, it is required to manually configure all configurations on the active and backup machines first, and finally enable HRP dual-machine configuration.
- A. True
- B. False
Answer: B
NEW QUESTION # 158
Among the following priority queues, which queue has the highest default priority?
- A. AC_BK
- B. AC-VI
- C. AC_Vo _ _
- D. AC_BE
Answer: C
NEW QUESTION # 159
Which of the following intelligent traffic steering policies are supported by Huawei's SD-WAN Solution?
- A. Application priority-based traffic steering
- B. Bandwidth-based traffic steering
- C. Load balancing-based traffic steering
- D. Link quality-based traffic steering
Answer: A,B,C,D
Explanation:
Traffic steering optimizes SD-WAN. The HCSP-Presales-Campus Network Planning and Design V1.0 documentation lists:
NEW QUESTION # 160
When SecoManager is delivered as an independent product (not integrated with Master NCE- Fabric and deployed), the threat linkage function with HiSec insight supports the delivery of blocking policies to switch devices.
- A. True
- B. False
Answer: B
NEW QUESTION # 161
......
Huawei H19-401_V1.0 Exam is a valuable certification for IT professionals who want to advance their careers in network planning and design. HCSP-Presales-Campus Network Planning and Design V1.0 certification demonstrates that the candidate has the knowledge and skills required to design and implement complex campus network solutions using Huawei technologies. Additionally, this certification is recognized globally, making it a valuable asset for IT professionals who want to work for multinational companies or organizations that use Huawei technologies. Overall, the Huawei H19-401_V1.0 Exam is a challenging but rewarding certification that can help IT professionals take their careers to the next level.
Latest Questions H19-401_V1.0 Guide to Prepare Free Practice Tests: https://www.actual4test.com/H19-401_V1.0_examcollection.html
H19-401_V1.0 Practice Exam - 892 Unique Questions: https://drive.google.com/open?id=19nib5yY0wQk-ES6kp5Yk3WTR4JJImbUK